Copyright © 2008 Huawei Technologies Co., Ltd. All Rights Reserved No part of this document may be reproduced or transmitted in any form or by any means without prior written consent of Huawei Technologies Co., Ltd. Trademarks and Permissions Ltd. and other Huawei trademarks are trademarks of Huawei Technologies Co., All other trademarks and trade names mentioned in this document are the property of their respective holders. Notice The information in this document is subject to change without notice.
Table of Contents What Is in Your Package ........................................................................ 1 Getting to Know Your E156C................................................................... 2 Preparation ......................................................................................... 5 Installation/Removal Guide..................................................................... 7 Safety Information .............................................................................
Thank you for choosing Huawei E156C HSDPA USB Stick (hereinafter referred to as the E156C). With the E156C, you can access the Internet through wireless network at a high speed. Note: This manual describes the appearance, installation and removal of the E156C. For the operation of the management program, refer to the User Manual.
Getting to Know Your E156C The following figure shows the appearance of the E156C. It is only for your reference. The actual product may differ. 1 2 3 4 6 5 ΠUSB Interface It connects the E156C to a computer.
• SIM/USIM Card Slot It is where you insert the subscriber identity module/UMTS subscriber identity module (SIM/USIM) card. Ž Micro SD Card Slot It is where you insert the Micro Secure Digital Memory (SD) card • RF testing slot It connects the RF test cables for RF testing. • Strap Hole ‘ Indicator It indicates the status of the E156C. Colour Status Green Blinking (on for 100ms and off for 100ms; then on for 100ms and off for 2700ms) The E156C is powered on.
network. Cyan On The E156C is connected to a HSDPA network. - Off The E156C is removed.
Preparation Requirements for the Computer To use the E156C, the computer should meet the following requirements: n USB Type A Receptacle, Compatible with USB 2. 0 High Speed. n Windows 2000 SP4, Windows XP SP2, Windows Vista. n Your computer’s hardware system should meet or exceed the recommended system requirements for the installed version of OS. n Resolution for the display: 800 × 600 or above. Getting Your E156C Ready 1. Remove the USIM/SIM card slot from the E156C. 2.
Inserting the Micro SD Card (Optional) Insert the micro SD card into the E156C, as shown in the following figure. Note: Do not remove the micro SD card when it is being used. Removing the card during an operation may damage the micro SD card as well as the device, and data stored on the card may be corrupted.
Installation/Removal Guide On different operating systems (OSs), the installation and removal procedures may differ. Follow the system prompts during operation. Connecting the E156C with a Computer Note: First, power on the computer. Then connect the E156C with the computer. Otherwise, the E156C cannot be installed as normal. 1. Plug the E156C into the USB interface of the laptop or desktop computer. You can connect the E156C to a laptop or desktop computer using the USB cable for better signals.
2. The OS automatically detects and recognises new hardware and starts the installation wizard. 3. Follow the prompts of the installation wizard. 4. After the program is installed, a shortcut icon for the E156C management program is displayed on the desktop. Starting the Management Program After the E156C is installed, the management program is launched automatically. Then every time the E156C is connected to the PC, the management program is launched automatically.
E156C. Note: Before removing the management program, exit the management program.
Safety Information Read the safety information carefully to ensure the correct and safe use of your wireless device. Interference Do not use your wireless device if using the device is prohibited or when it cause danger or interference with electric devices. Medical Device n Do not use your wireless device and follow the rules and regulations set forth by the hospitals and health care facilities. n Some wireless devices may affect the performance of the hearing aids.
n Area where the air contains chemical substances and particles (such as granule, dust, or metal powder) n Area indicated with the "Explosives" sign n Area indicated with the "Power off bi-direction wireless equipment" sign n Area where you are generally suggested to stop the engine of a vehicle Traffic Security n Observe local laws and regulations while using the wireless device. To prevent accidents, do not use your wireless device while driving.
WEEE Approval The wireless device is in compliance with the essential requirements and other relevant provisions of the Waste Electrical and Electronic Equipment Directive 2002/96/EC (WEEE Directive). RoHS Approval The wireless device is in compliance with the restriction of the use of certain hazardous substances in electrical and electronic equipment Directive 2002/95/EC (RoHS Directive). Laws and Regulations Observance Observe laws and regulations when using your wireless device.
considerably low or high temperature. n Use only accessories of the wireless device approved by the manufacture. Contact the authorized service center for any abnormity of the wireless device or accessories. n Do not dismantle the wireless device or accessories. Otherwise, the wireless device and accessories are not covered by the warranty. Emergency Call This wireless device functions through receiving and transmitting radio signals. Therefore, the connection cannot be guaranteed in all conditions.
(W/kg) averagedover 10 grams of tissue for the body or head (4.0 W/kg averaged over 10 grams of tissue for theextremities - hands, wrists, ankles and feet). The standard incorporates a substantial margin ofsafety to give additional protection for the public and to account for any variations inmeasurements. the highest SAR value for this device when tested properly worn on the body is 1.080W/kg.
NOTICE: This device complies with Part 15 of the FCC Rules [and with RSS-210 of Industry Canada]. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 15.21 NOTICE: Changes or modifications made to this equipment not expressly approved by (HUAWEI) may void the FCC authorization to operate this equipment. 15.
receiver is connected. • Consult the dealer or an experienced radio/TV technician for help.
Acronyms and Abbreviations EDGE Enhanced Data Rates for GSM Evolution GPRS General Packet Radio Service GSM Global System for Mobile Communications HSDPA High Speed Downlink Packet Access OS Operating System PIN Personal Identification Number SAR Specific Absorption Rate SIM Subscriber Identity Module UMTS Universal Mobile Telecommunications System USB Universal Serial Bus USIM UMTS Subscriber Identity Module WCDMA Wideband Code Division Multiple Access 17
Version: V100R001_01 18 Part Number: 31019601
