User's Guide

 If the automatic loading function is enabled for the

RRU3606, the RRU3606 automatically loads software

from the BAM.

 If the auto-loading function of the RRU3606 is

disabled, run the DLD CBTSSW command to load the

software.

Step 8 Unblock the carriers.

Run the UBL RES command to unblock the carriers.

Step 9 Ensure that the new CRFU module is functional.

RUN indicator: ON for 1s and OFF for 1s.

----End

Postrequisite

After replacing the CRFU, perform the following steps:

1. Record the software version, board name, slot number, and site name of the

faulty board.

2. Check whether there is visible physical damage on the board, for example,

mechanical parts or plug-ins are distorted, pins are bent or missing, or the board is

burnt.

3. Record the information about the fault location process, including the cause

of the fault, fault symptoms, alarm name, status of indicators on the board panel,

and detailed procedures for identifying and clearing the fault on site.

4. Place the faulty board in an antistatic bag. Then, place the onsite fault record

and the antistatic bag in the board box, and store them properly.