CG1241/CG1241D Cable Modem Quick Start
Chapter 1: Safety Precautions To use the device properly and safely, read the safety precautions carefully before using the device and strictly observe these precautions when using the device. Safety precautions: Keep the device out of the reach of children as the components or accessories may be swallowed. Install the device in strict compliance with the requirements of the supplier. Reserve a space of at least 10 cm above and around the device for heat dissipation.
Chapter 2: Introduction CG1241/CG1241D is a residential VoIP cable modem which has an 802.11bgn WiFi access point that gives you wireless connection to the Internet with 4 Giga Ethernet ports which further expand the Local Area Network (LAN) capabilities. CG1241D provides additional 802.11 WiFi interface supports 802.11A/N capability. If you have subscribed to phone services from your cable operator then you will be able to place normal phone calls using your analogue phone and/or fax machine.
Chapter 3: Overview Front Panel The following illustration shows the front panel of the EMTA: Power - Indicates the Power status. DS - Indicates the status of Data reception by the cable modem from the Network (Downstream Traffic). US - Indicates the status of Data transmission by the cable modem to the Network (Upstream Traffic). Online - Displays the status of your cable connection.
There will be 12 LEDs on CG1241/CG1241D Looking at LED from TOP to Bottom: Power, DS, US, Online, LAN1, LAN2, LAN3, LAN4, WiFi, PHONE1, PHONE2, WPS. Internet LAN CG1241/CG1241D Power ON Boot-up Operation Wi-Fi Phone1 Phone2 WPS DS US Online ON ON ON ON 0.25 second ON FLASH FLASH FLASH ON ON 2 3 4 ON ON ON ON X ON ON X Power on 0.
Rear Panel Connector Description Slot Description CABLE RESET ETHERNET 1 2 3 4 TEL 1 2 12VDC DC Power switch F-Connector Reset/Reboot this Cable modem Ethernet 10/100/1000 BaseT RJ-45 connector Telephony RJ-11 connector 12V DC-IN Power connector Power ON/OFF switch 3
Side Panel for WPS WPS – Indicates the status of the WPS (Wi-Fi Protected SetupTM) functionality. There is one WPS button on the Top Side Panel of CG1241/CG1241D and is designed to have multiple function. This button can be used to: Securely and Simply Get WiFi Client Connected: WPS button can be used to paring WiFi client which also supports WPS function. A long press (press more than 5 seconds) on the WPS button will enable CG1241/CG1241D scan for any available WPS device.
Chapter 4. Connecting the Residential VoIP cable modem to Your Computer Installation Procedure for Ethernet Interface Follow the steps below for proper installation: 1. Ensure the ON/OFF switch, on the rear panel, is on position ON = ‘1’. 2. Connect one end of the coaxial cable to the CABLE connection on the wall, and the other end to the CABLE jack on the CG1241/CG1241D. 3. Connect the plug from the power supply into the POWER jack on the CG1241/CG1241D, and plug the power supply into an AC outlet.
Chapter 5. WEB Configuration If enabled by your service provider; please proceed as follows: 1. 2. Once your host PC is properly configured. Start your web browser and type the private IP address of the EMTA on the URL field: 192.168.1.1. After connecting to the URL, you can see the login page. Please enter the username, password and then press Login button. The default username is "admin" and password is "password". Fig.
Chapter 6. Technical Specification 1. Power Requirements : Power adaptor requirement : Input: 100V~240VAC±10% Output: 12VDC 2A Plug Type: Two round pins Frequency: 50-60 Hz±10% Power Consumption : 24W DC voltage tolerance : 11.4V~12.6V Power requirement : on/off DC power switch on housing 2.
Chapter 7. Wireless SSID and WPA Pre-shared Key Default SSID and WPA Pre-shared Key on the CM Lable. Note: If you want to change your SSID and WPA Pre-shared Key, please connect webpage. Fig.
CAUTION for UL North American Cable Installer: This reminder is provided to call your attention to Article 820.93 of the National Electrical Code (Section 54 of the Canadian Electrical Code, Part 1) which provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building as close to the point of cable entry as practical.
Warranty Card Thank you for choosing Huawei Technologies Co., Ltd. To get better services, please read this warranty card carefully, fill in the required information, and preserve this card in good condition. PERSONAL OR COMPANY FULL NAME Address/Postal Code Telephone Number Email Product Type Product Serial Number Purchase Date Invoice Number Dealer's Name Dealer's Address Dealer's Telephone Preserve well. No reissue.
Limited Warranty Subject to the exclusions contained below, Huawei Technologies Co., Ltd. (referred to as Huawei) warrants its access terminals ("Products") to be free from defects in materials and workmanship under normal consumer usage for one year from the date of purchase of the product ("Warranty period"). During the warranty period, a Huawei authorized service partner shall remedy defects in materials and workmanship free of charge. Special Notice: 1.
Copyright © Huawei Technologies Co., Ltd. 2015. All rights reserved. No part of this document may be reproduced or transmitted in any form or by any means without prior written consent of Huawei Technologies Co., Ltd. Trademarks and Permissions and other Huawei trademarks are trademarks of Huawei Technologies Co., Ltd. All other trademarks and trade names mentioned in this document are the property of their respective holders. Notice The information in this document is subject to change without notice.
Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. Note: The country code selection is for non-US model only and is not available to all US model. Per FCC regulation, all WiFi product marketed in US must fixed to US operation channels only.
