Instruction Manual

If an emergency occurred in machining, such as the workpiece being loose from holding, components

damaging, unusual light or sound coming from the machine, etc. Press the main button or E-Stop

button, all ongoing procedures will stop immediately, or cut off the power to shut it down. Carvera is

built by closed-loop servo motors, and it saves the coordinates and status at each step. Therefore, no

need to recalibrate after reboot, just restart the job.

Carvera has a safety option that allows the machine to automatically stop working when opening the

cover, which is useful for schools or work environments where children may reach.

Please read this manual carefully before using the Carvera. Failure to read the manual may

lead to personal injury, inferior results, or damage to the Carvera products.

This manual is provided for reference purposes only. We reserve the right to modify or revise

this manual, users can download the most up-to-date version of this manual on our website.

Carvera is equipped with multiple sensors (Motor stall sensor, Spindle abnormal sensor,

etc.). However, you should always pay attention in operation that milling cutters revolving in

high-speed, unstable components or laser in operation are dangerous to people without

protection. Please carefully read the safety instructions below to avoid unnecessary casual-

ties.

1. Always wear safety goggles when operating Carvera, especially when the protective cover

is open.

2. Always wear laser protection goggles when using laser function.

3. Please wear hearing protection when Carvera is machining on the hard materials.

4. Do not put your hands close to the spindle or machining area. Keep the protective cover

closed when operating Carvera.

5. Do not leave your Carvera unattended while it is machining.

6. Please be aware of the sharpness of the milling bits during installation, dust collection,

and other operations.

7. Milling and laser carving will generate heat. Inappropriate parameters will cause fire

hazards. Make sure an extinguisher is in your vicinity.

8. Some materials are harmful to people when machining or laser craving, such as carbon

fiber and epoxy resin. Please wear a face mask and turn on the automatic dust collection.

9. Do not expose this machine to rain or wet conditions.

10. Keep children and bystanders away while operating this machine. It requires supervision

and the assistance of an adult when children use this machine.

Disclaimer

Safety Instructions

Safety