Instruction Manual

Rotary Module

1. Installation: As shown in the figure, fix the rotary module with two 4mm dowel pins and six M5*20

screws. Plug the motor cable into the 4 pin socket on the left side of machine bed. Please reboot the

machine to enable the rotary module.

2. Chuck Jaws Assembly: As shown in the figure, there are two assembly positions. The standard

position is suitable for small workpieces, and the reversed position is suitable for bigger-diameter

workpieces. The default position is reversed to fit our 4th axis example. You can change it to stan-

dard according to your needs. The assembly order should refer to the '1, 2, 3, 4' numbers marked on

the jaws.

5. Dust bypass: The built-in dust collection system is not very powerful and the capacity of the dust bin

is limited, the Carvera supports the bypass of dust to external dust collection devices such as a

vacuum cleaner:

5.1. Switch the end of the dust pipe (L-shape) to the bypass input channel as shown.

5.2. Connect your vacuum cleaner to the bypass output channel on the back of the machine, the inner

diameter is 22mm.

Note: Do not lock the dust shoe at the bottom to avoid affecting the automatic tool change

function.

Note: The built-in vacuum power is limited, bring your own vacuum cleaner to clean.

Note: When using 4th axis, remove the dust shoe and dust bin for interference free.

The bypass

input channel

Chuck jaws

standard position

The dust collec-

tion channel

The bypass

output channel

Chuck jaws

reversed position

Tool Kit

48 49