Instruction Manual

2.3. Scan Margin: Scan the rectangle path area before machining. When scanning, machine will switch

to the wireless probe and turn on the red laser for observation. We recommend new users turn on this

while running job.

2.4. Auto Z Probe: Z-axis tool setting is required after changing the workpiece or the zero points of the

work coordinate. When doing Z probe, machine will automatically switch to the wireless probe and do

probe at the set position.

Work Origin: Perform Z axis probe at a certain distance related to the X/Y axis of the working

coordinate zero point.

Path Origin: Perform Z axis probe at a certain distance related to the actual X/Y machining starting

point (lower left corner). This method is selected by default.

2.5. Auto Leveling: If requiring uniform machining depth, please select the automatic leveling option

such as PCB engraving. You can set the leveling matrix size and the lifting height when moving

horizontally during the leveling process. The less the flatness, the higher the lifting height needs to be.

The higher the requirement for machining consistency, the denser the matrix. For PCB engraving, it is

better to have matrix dots spaced about 1 cm apart.

2.6. Run: Click to start machining process. If you set the scanning area, Z-axis tool setting or automatic

leveling, the G-Code file will be executed after the automatic detection is completed.

G-Code/MDI

1. G-Code interface: Display the currently opened remote or local G- Code file. When the task is

running, it will track and highlight the running line in real-time.

2. MDI: Display detailed send/receive commands, similar to the log information. In specific cases, you

can manually enter the g-code for operation and diagnosis. Enter “clear” to clear the current command

area.

3.1. Task pause: Pause the running G-Code task and you can manually control the machine afterwards.

But if you want to resume the task, please remember to turn on the spindle, or it may damage the tool if

it resumes without rotating the spindle.

3.2. Task stop: Terminate the current G-Code task.

3.3. Task hold: Similar to task pause, but the pause speed is faster and cannot control the machine

manually during holding.

3.4. Task track: Display the current G-Code task name, running time, percentage and other information.

3.5. Emergency stop: Immediately stops the current task, turn off the spindle, the same function as the

physical button in front the machine.

3、Task control

Note: The wireless probe is a precise device that integrates mechanics and electronics, which is

easy to damage. Please be careful when using it. Make sure no obstacles can block its way. We

suggest new users turn on the scan margin function to preview the route. It is recommended to leave

sufficient margin between L bracket position and path start point, greater or equal to 10/10mm.

Note: The current task cannot be stopped immediately when the task is paused or held. It has to

wait for the buffer zone finish. If emergency occurs that needs to stop the machine immediately,

please click the emergency stop button in the software or press the physical emergency stop

button on the front panel of the machine. Carvera is built by closed-loop servo motors, and it

saves the coordinate and status at each step. Therefore, no needs to reset the tool after

reboot/unlock.

Software