Instruction Manual

4、Spindle status and control
4.1. Symbol: Spindle icon
4.2. Main data: Real-time spindle rotary speed (RPM)
4.3. Sub-data: Target spindle rotary speed/ Spindle speed scale/Real-time spindle temperature
(moving message)
4.4. Drop-down list:
4.4.1. Spindle Status: Target spindle rotary speed/ Spindle speed range /Real-time spindle
temperature summary display
4.4.2. Auto Vacuum: Choose to turn on/off auto vacuum while the spindle is rotating. Default - on.
4.4.3. RPM Scaling: Set the spindle speed range by percentage. For safety reasons, the adjust-
ment amount range is limited from 50% to 200%.
5.1. Symbol: Tool icon
5.2. Main data: Display the number 1 to 6 of the current tool on the spindle, no tool - “None”, wireless
probe - “Probe”
5.3. Sub-data: Current Tool Length Offset（TLO）/Wireless Probe Power(moving message)
5.4. Drop-down list:
5.4.1 Tool Status: TLO/Wireless Probe Power summary display
5.4.2. Change tool: Change to the selected tool or wireless probe, and perform automatic calibra-
tion.
5.4.3. Calibrate tool: Automatically calibrate the current tool and set TLO.
5.4.4. Drop tool: Drop the current tool.
5.4.5. Set tool: Manually set the current tool number. Only use when the tool number is wrong.
5、Tool status and control
Note: Adjusting the feed rate will not take effect immediately. Generally, it will take a few
seconds to wait for the current command to finish.
Note: Turn on the Vacuum or adjust the spindle rotary speed will not take effect immediately.
Generally, it will take a few seconds to wait for the current command to finish.
2、Coordination status and control
2.1. Symbols: X/Y/Z/A
2.2. Main data: Work coordinate (The position of the tool relative to the work zero point). The position
depends on where you put your workpiece and where you want to start on the workpiece.
2.3. Sub-data: Machine coordinates (The position of the tool relative to the machine’s zero point). The
position is fixed and located in the upper right corner of the machine, so the coordinates are generally
negative.
2.4. Drop-down list:
2.4.1 Set Origin: The working coordinates of four axes - X/Y/Z/A can be set to zero. Carvera usually
uses 2 fixed anchor points to set the starting point automatically, so we do not recommend setting the
origin point by yourself.
2.4.2 Rotary axis (A axis) does not distinct work coordinates and machine coordinates, and there is
a “Shrink” function in the drop-down list, which can calculate the remainder according to 360 when
having large rotation angles.
3.1. Symbol: Feed icon
3.2. Main data: Real-time feeding speed
3.3. Sub-data: Target feeding speed/Feeding speed scale(moving message)
3.4. Drop-down list:
3.4.1. Feed Status: Target feeding speed /Feeding speed scale
3.4.2. Speed Scaling: Set the feed rate by percentage. For safety reasons, the adjustment range is
limited to 50% to 200%
26
Software
27
Software