Instruction Manual

The purpose of configuring WIFI is to allow Carvera to join the network at your workplace so that your

computer can control the machine without being restricted.

1. The network can be configured via a USB cable or the machine’s built-in WiFi accessing point.

WiFi Configuration

2. Connect via USB: Connect the USB cable and open the Carvera control software.

Click the status button in the status bar, click “USB...”, you will see your USB device and choose one to

connect. Then the status button will be updated, displaying machine is connected in USB mode.

3. Connect via accessing point: Open the WiFi setting on your computer, find the accessing point

named CARVERA_WIFI_XXXXX and connect (No password). After successfully connected, open the

Carvera control software; click the status button in the status bar; click” WIFI…”;Carvera will automati-

cally search connectable devices. Please refresh it if Carvera cannot find any devices. After connect-

ing to the device, the status button will be updated; displaying machine is connected in WiFi mode.

4. WiFi configuration: Click the “more” button (end of the status bar) in the status bar; click the WIFI

icon, the system will start searching WIFI in the workplace. Select a WIFI, enter the password and

connect. Please retry if the connection failed.

5. Disconnect: Click the status button; click “Disconnect”; Switch back to your WiFi.

6. Redo step 3 from Click “WIFI”to connect Carvera through WIFI.

Charge Wireless Probe

The wireless probe is one of the main components of Carvera. It is an indispensable component for

Z-axis tool setting and automatic leveling. Please fully charge it before using it for the first time.

1. After the device is turned on, the yellow indicator light will light up as the wireless probe automati-

cally starts charging.

2. Please charge the wireless probe for at least 30 minutes or the yellow indicator light runs out which

means it’s fully charged. If the machine is used frequently (at least once a week), then there is no need

to charge it every time.

Control Software Installation

1. Goto www.makera.com, download and install the Carvera control software（Now support comput-

er/pad/phone with Windows/Mac/Android system, will add IOS/Linux support later）. We suggest

using computer version control software for the first time. Please turn to the next chapter for the

software instruction.

2. Download and install the Carvera USB driver if you intend to use the USB connection method.

对刀器红灯

Recommended

Preparation