Instruction Manual

Tool Preparation

For easy transportation, the tools are not loaded by default. Please put the wireless probe and milling

bits into right positions as shown in the figure. You can find the wireless probe in the accessory box,

milling bits in the tool box and the optional solder mask removal tool in the PCB pack. The default tool

installed is a test rod (No 6 tool).

This 1-6 tool positions are for the examples. If you run your own toolpath in the future, you should

layout your tools accordingly.

Adjust Dust Shoe

The default state of the dust shoe is locked. To use the vacuum system correctly you need to unlock

the dust shoe first. Pull the plug outwards, rotate it for about 30 degree, make sure it is unlocked, thus

the dust shoe can go up and down freely (Locking and unlocking modes are toggled every 30 degrees

of rotation). For other instructions on the vacuum system, please turn to Chapter 6.

For the sake of transportation, the phone/pad stand has not been preinstalled. To install it, remove the

screws at the stand base, put the stand on and screws it. Please note that the notch should be in the

same direction as the USB port (charging only).

For your convenience, the phone/tablet stand can be installed on either the right or left side of the

machine. The default is the right side.

Phone/Pad Stand Installation

1st

Tool 1:

Tool 2:

Tool 3:

Tool 4:

Tool 5:

Tool 6:

1/8" Single Flute Bit 25mm

Wireless Probe

1/8" 30 degree 0.2mm V-bit

1/8" 0.8mm Corn Bit

1/8" Single Flute Bit 12mm

UV solder mask removal tool（Optional）

1/8" test rod

Preparation