User Manual

ManualsBrandsHTZSAFE ManualsElectronicsExtra 1/4 Mile Solar Wireless Weatherproof Outdoor Motion Sensor for HTZSAFE Driveway Alarm(The Sensor Eye with The Cover)

Table Of Contents

Solar Wireless Motion Sensor

User Manual

1. System Components And Usage

ON/OFF

Charge Jack

Charge Jack:used to connect the additional solar panel

or DC 5V power adapter

ON/OFF:sensor on/off

Sensor Eye

Sensor Eye: detects heat movements

Solar Panel:charges the built-in battery of the sensor

Solar Panel

Drain Hole:used to drain out the rainwater(please note the

drain hole must be facing down when you install the sensor)

Drain Hole

Summary of content (10 pages)

PAGE 1
Solar Wireless Motion Sensor User Manual 1.
PAGE 2
ATTENTION PLEASE The KIT includes a USB charging cord(only the cord, not the USB plug),which is used to charge the solar wireless motion sensor before use or after pro-longed low light conditions causing low battery. Please kindly connect the charging cord with your own USB plug(such as the direct USB outlet, the phone's USB plug or computer's USB, etc.).
PAGE 3
2.
PAGE 4
Step 3 Press and hold the “Volume” button for 5 seconds and release the button when you hear a beep prompt and the indicator light flashes; flashing slowly light up Volume Volume press and hold the Volume button for 5 seconds release the button Step 4 Activate The Wireless Motion Sensor (wait about 30 seconds after you turn on the sensor) 1st method:press the ON/OFF button twice ON/OFF (press twice) (the light of the ON/OFF button will flash once meaning the motion sensor was activated and sent the
PAGE 5
2nd method: Ensure the sensor is turned away from you.
PAGE 6
Step 7 Installation Wireless Motion Sensor long screws 1 short screws 2 3 6
PAGE 7
Installation Notes: 1. Please fix the motion sensor tightly to ensure the position and the direction will not be moved easily by wind. 2.Please point the sensor towards a open field (not towards the trees or bushes) 3.
PAGE 8
4.please point the sensor eye towards to the engine or exhaust pipe if for detecting vehicles.(the working principle of the senor is detecting the movements with heat sources) (2)How to delete the sensors of the receiver Step 1 Plug the receiver into an outlet Step 2 Press and hold both the “Volume” button and “Melody” button for 10 seconds and release the buttons when you hear a long beep prompt; Note: all the sensors will be deleted by this operation.
PAGE 9
(3)How to adjust the alarm volume Step 1 Plug the receiver into an outlet Step 2 Press the “Volume” once to adjust the volume of the receiver.
PAGE 10
Step 2 If select Low sensitivity---turn on the sensor by pressing the ON/OFF button 3 times If select Medium sensitivity---turn on the sensor by pressing the ON/OFF button 4 times If select High sensitivity---turn on the sensor by pressing the ON/OFF button 5 times 3.