User Manual

Step 3
Note:
Activate the sensor.
please have the sensor close to the plug-in receiver
when programming.(within 30FT )
3. Other Settings
(1)How to add additional sensors to the receiver
(up to 4 sensors can be added to one or multiple receivers)
Step 1
Plug the receiver into an outlet
ON/OFF
( twice)press
(the light of the ON/OFF button
will flash once meaning the motion
sensor was activated and sent
the wireless signal)
Step 2
All the Zone
numbers light up
one of the
zones flashing
slowly
Press and hold the “Volume” button for 5 seconds, release the
button when one of the zone number flashing and a beep prompt
Volume
press and hold the button
for 5 seconds
Volume
release the button
Volume
(
quickly and a ring tone prompt
meaning the sensor has been
added to the plug-in receiver
properly)
Zone number flashing
flashing
quickly
8