Use and Care Manual

If you use bromine you should: If you use bromine you should:

Each time your spa is freshly filled

with water you will need to add

one-half ounce of HTH Spa

™

Brom-

Start per 100 gallons of water to

establish an immediate 30 ppm

bromide reserve. The bromide reserve

keeps the system completely bromine

based, to eliminate odors and to

ensure maximum water comfort to skin and eyes.

The 30 ppm bromide reserve is not the same as the

2 – 4 ppm bromine level that must be maintained on

a daily basis. Any time the spa is drained and refilled

HTH Spa

™

Brom-Start will need to be added.

Balance: Test and adjust the total alkalinity,

calcium hardness and pH of the water (see

“Balanced Spa Care” on page 6 for specific

levels).

Sanitize: Add HTH Spa

™

Brominating

Tablets to the HTH

Spa and

Pop-up Pool Floater. Test and

adjust the bromine residual. Do

not enter the spa until the

bromine residual level is in the

range of 2 – 4 ppm. Bromine

levels should be maintained in the

range of 2 – 4 ppm.

To convert your spa from bromine to chlorine or vice

versa, simply drain your spa and refill it with fresh

water.

1-866-HTH-POOL

Eng_SpaGuide_wp.indd Sec1:5Eng_SpaGuide_wp.indd Sec1:5 5/22/09 2:34:07 PM5/22/09 2:34:07 PM