Use and Care Manual

Maintain Step 2: SanitizeMaintain Step 2: Sanitize
Spas operate at a high temperature (up to
104º F/40º C), which can create a high rate of water
evaporation and an environment that may promote
the growth of bacteria and algae. Heavy use of your
spa can cause the water to become cloudy and dull.
It may also cause your spa to develop a tendency
towards corrosion, staining and/or scaling.
Proper sanitization can help prevent and remedy
these situations. However, if a specific problem
occurs, check the HTH Spa
™
Problems and Solutions
Chart on pages 20 – 21 for a solution.
If you use chlorine you should:If you use chlorine you should:
Use HTH Spa
™
Chlorinating Sanitizer to
maintain the FAC in the range of 3 – 5 ppm.
During periods of heavy use or reduced water
circulation, add an additional dose of
HTH
Spa
™
Chlorinating Sanitizer.
HTH SpaHTH Spa
™
Chlorinating Sanitizer Chlorinating Sanitizer
This product kills bacteria and is a
convenient routine chlorinator. For best
results, refer to “Balanced Spa Care” on
page 6. If circulation is low, stir the spa
water after the addition of chlorine or
other chemicals.
11
1-866-HTH-POOL
Eng_SpaGuide_wp.indd Sec1:11Eng_SpaGuide_wp.indd Sec1:11 5/22/09 2:34:12 PM5/22/09 2:34:12 PM