SDS

SAFETY DATA SHEET
HTH Metal and Stain Defense
REVISION DATE : 05/27/2015 Page 4 of 10
Land Release:
Create a dike or trench to contain materials. Absorb spill with inert
material (e.g., dry sand, clay, earth or commercial absorbent), then
place in a chemical waste container. Decontaminate all clothing and
the spill area using a detergent and flush with large amounts of
water. Contain all liquid for treatment and/or disposal as a (potential)
hazardous waste.
Additional Spill Information :
Remove all sources of ignition. Stop source of spill as soon as
possible and notify appropriate personnel. Utilize emergency
response personal protection equipment prior to the start of any
response. Evacuate all non-essential personnel. Dispose of spill
residues per guidelines under Section 13, Disposal Consideration.
SECTION 7. HANDLING AND STORAGE
Handling:
Do not take internally. Avoid contact with skin, eyes and clothing.
Upon contact with skin or eyes, wash off with water. Avoid breathing
mist or vapor.
Storage:
Store in a cool dry ventilated location, away from sources of ignition
or other incompatible conditions and chemicals. Keep container(s)
closed.
Incompatible Materials for Storage:
oxidizers, Bases
SECTION 8. EXPOSURE CONTROLS/PERSONAL PROTECTION
Ventilation:
Local exhaust ventilation is recommended if vapors, mists, aerosols or dusts
are generated. Otherwise, use general exhaust ventilation.
Protective Equipment for Routine Use of Product
Respiratory Protection :
Respiratory protection not normally needed. If vapors, mists, aerosols or
dusts are generated, wear a NIOSH approved respirator.
Respirator Type :
A NIOSH approved full-face or half-face respirator in combination with
chemical goggles. A NIOSH approved air purifying respirator with P100
filter. Air purifying respirators should not be used in oxygen deficient or IDLH
atmospheres or if exposure concentrations exceed ten (10) times the
published limit.
Skin Protection :
Wear impervious gloves to avoid skin contact.
Eye Protection:
Use chemical goggles and a faceshield.
Protective Clothing Type:
Impervious
General Protective
Measures:
An eye wash and safety shower should be provided in the immediate work
area.
Components with workplace control parameters
no data available