Your HTC 7 Trophy User guide
Conventions used in this guide In this user guide, we use the following symbols to indicate useful and important information: This is a note. It might give extra information that’s only applicable in certain situations. Or explain a specific feature in a bit more detail. This is important info. Stuff you really need to know to accomplish a task or get a feature to work properly. This is a tip. It might provide an alternative way to do something or tell you about a special option you might find useful.
Basics Inside the box You’ll find the following inside the box: Phone Battery USB cable 3.
12 Basics Your phone Front panel 1 7 2 1 Earpiece 2 Touch screen 3 BACK 4 Microphone 3 6 5 5 SEARCH 6 START 7 Notification LED 1 POWER 2 3.
Basics 13 Left and right panels 1 2 1 VOLUME UP/DOWN 2 USB connector 3 CAMERA 3
14 Basics Back panel 1 2 3 4 1 5 megapixel camera 2 LED flashlight 3 Back cover 4 Speaker
Basics 15 Back cover Removing the back cover Remove the back cover to access the battery compartment and SIM card slot. 1. With the phone turned off, hold your phone securely with the front facing down. 2. With your thumb or finger, lift up the back cover from the small notch at the top of the phone. Replacing the back cover 1. Secure the bottom part of the back cover first by aligning the tabs on the back cover into the openings located inside the battery compartment. 2.
16 Basics Battery Your phone uses a rechargeable battery. Please use only original batteries and accessories that came with your phone or replacements that we recommend. How long the battery can last before it needs recharging depends on how you use your phone. Among these are the phone features and accessories you use (for example, leaving your Bluetooth connection always on uses more power). Long phone calls and frequent web browsing use up much battery power.
Basics 17 Removing the battery 1. Take the back cover off. See “Removing the back cover”. 2. Lift the battery from the groove at the upper left side of the battery compartment to remove the battery. Charging the battery The battery is partially charged when shipped. Before you turn on and start using your phone, it is recommended that you charge the battery. Some batteries perform best after several full charge/ discharge cycles.
18 Basics 1. Connect the bigger end of the USB cable to the power adapter. 2. Connect the smaller end of the USB cable to the phone. 3. Plug in the power adapter to an electrical outlet to start charging the battery. Your phone may turn on when the battery is being charged. As the battery is being charged, the notification LED shows a solid red light when the battery is being charged. The light turns to solid green when the phone is fully charged.
Basics 19 Switching your phone on or off Switching your phone on Press the POWER button. Easy. When you turn on the phone for the first time, you’ll need to set it up. Go to “Setting up your phone for the first time” and we’ll take you through it. Switching your phone off 1. If the display is off, press the POWER button to turn it back on. 2. Unlock your phone if the Lock screen is displayed. See “Unlocking the screen” in the Getting started chapter. 3.
20 Basics Finger gestures Tap When you want to type using the keyboard, select items onscreen such as apps and settings, or press onscreen buttons, simply tap them with your finger. Press and hold To open the available options for an item (e.g. contact or link in a web page), simply press and hold the item. Swipe or slide To swipe or slide means to quickly drag your finger vertically or horizontally across the screen. Drag Press and hold your finger with some pressure before you start to drag.
Safety and regulatory guide
Safety and regulatory guide Please read before proceeding THE BATTERY IS NOT FULLY CHARGED WHEN YOU TAKE IT OUT OF THE BOX. DO NOT REMOVE THE BATTERY PACK WHEN THE PHONE IS CHARGING. YOUR WARRANTY IS INVALIDATED IF YOU DISASSEMBLE OR ATTEMPT TO DISASSEMBLE THE DEVICE. Privacy restrictions Some countries require full disclosure of recorded telephone conversations, and stipulate that you must inform the person with whom you are speaking that the conversation is being recorded.
Safety and regulatory guide Electrical safety This product is intended for use when supplied with power from the designated battery or power supply unit. Other usage may be dangerous and will invalidate any approval given to this product. Safety precautions for proper grounding installation CAUTION: Connecting to an improperly grounded equipment can result in an electric shock to your device. This product is equipped with a USB Cable for connecting with desktop or notebook computer.
Safety and regulatory guide • The phone should only be connected to products that bear the USB-IF logo or have completed the USB-IF compliance program. • Do not use a battery that appears damaged, deformed, or discolored, or the one that has any rust on its casing, overheats, or emits a foul odor. • Always keep the battery out of the reach of babies and small children, to avoid swallowing of the battery. Consult the doctor immediately if the battery is swallowed.
Safety and regulatory guide Explosive atmospheres When in any area with a potentially explosive atmosphere or where flammable materials exist, the product should be turned off and the user should obey all signs and instructions. Sparks in such areas could cause an explosion or fire resulting in bodily injury or even death.
Safety and regulatory guide Use only the supplied integral antenna. Use of unauthorized or modified antennas may impair call quality and damage the phone, causing loss of performance and SAR levels exceeding the recommended limits as well as result in non-compliance with local regulatory requirements in your country.
Safety and regulatory guide Device getting warm after prolonged use When using your device for prolonged periods of time, such as when you’re talking on the phone, charging the battery or browsing the Web, the device may become warm. In most cases, this condition is normal and therefore should not be interpreted as a problem with the device. Heed service markings Except as explained elsewhere in the Operating or Service documentation, do not service any product yourself.
Safety and regulatory guide Avoid pushing objects into product Never push objects of any kind into cabinet slots or other openings in the product. Slots and openings are provided for ventilation. These openings must not be blocked or covered. Air bags Do not place a phone in the area over an air bag or in the air bag deployment area. Store the phone safely before driving your vehicle. Mounting accessories Do not use the product on an unstable table, cart, stand, tripod, or bracket.
Safety and regulatory guide Regulatory agency identifications For regulatory identification purposes, your product is assigned a model number of PC40200. To ensure continued reliable and safe operation of your device, use only the accessories listed below with your PC40200. The Battery Pack has been assigned a model number of BB96100 or BTR6300B.
10 Safety and regulatory guide Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Safety and regulatory guide 11 M-Ratings: Phones rated M3 or M4 meet FCC requirements and are likely to generate less interference to hearing devices than phones that are not rated. M4 is the better/higher of the two ratings. PC40200 is rated M4. T-Ratings: Phones rated T3 or T4 meet FCC requirements and are likely to be more usable with a hearing aid’s telecoil than phones that are not rated. T4 is the better/higher of the two ratings. PC40200 is rated T4.
12 Safety and regulatory guide THIS MODEL DEVICE MEETS THE GOVERNMENT’S REQUIREMENTS FOR EXPOSURE TO RADIO WAVES. For body worn operation, this phone has been tested and meets the FCC RF exposure guidelines when used with the HTC Corporation. Accessories supplied or designated for this product. Use of other accessories may not ensure compliance with the FCC RF exposure guidelines. Your wireless mobile phone is a radio transmitter and receiver.
Safety and regulatory guide 13 FCC RF Radiation Exposure Statement This Transmitter has been demonstrated co-location compliance requirements with Bluetooth and WLAN. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.
14 Safety and regulatory guide RoHS compliance This product is in compliance with Directive 2002/95/EC of the European Parliament and of the Council of 27 January 2003, on the restriction of the use of certain hazardous substances in electrical and electronic equipment (RoHS) and its amendments.
Safety and regulatory guide 15
91H0xxxx-xxM Rev.A htc.
