User Guide

Tools and Calendar 169
The pairing and connection status is displayed below the hands-free headset or car kit name in the
Bluetooth phones section. When the Bluetooth headset or car kit is connected to your phone, the
Bluetooth connected icon is displayed in the status bar.
Reconnect a Headset or Car Kit
Normally, you can easily reconnect your headset by switching on Bluetooth on your phone, and then
turning on the headset. However, you might have to connect manually if your headset has been used with
another Bluetooth device.
Important: Make sure that the headset is discoverable. Refer to the headset manual for details.
1. With two fingers, swipe down from the status bar to open Quick Settings.
2. Touch the BLUETOOTH tile to turn Bluetooth on.
3. Touch below the BLUETOOTH tile to open the Bluetooth screen.
4. Touch the headset’s name in the Paired Devices section.
5. If prompted to enter a passcode, try 0000 or 1234, or consult the headset/car kit documentation
to find the passcode.
If you still cannot reconnect to the headset or car kit, follow the instructions in Disconnect From a
Bluetooth Device, and then follow the steps in Connect a Bluetooth Headset or Car Kit.
Disconnect From a Bluetooth Device
If you do not need to use Bluetooth at any given point, you can disconnect and unpair your phone from a
Bluetooth device.
1. With two fingers, swipe down from the status bar to open Quick Settings.
2. Touch the BLUETOOTH tile to turn Bluetooth on.
3. Touch below the BLUETOOTH tile to open the Bluetooth screen.
4. In the Paired Devices section, touch next to the device to unpair.
5. Touch Unpair.
Note: Touch the name of the device to reconnect it.
Send Information Using Bluetooth
You can use Bluetooth to transfer information between your phone and another Bluetooth-enabled device
such as a phone or notebook computer. The first time you transfer information between your phone and
another phone, you need to enter or confirm a security passcode. After that, your phone and the other
phone are paired, and you will not need to exchange passcodes to transfer information in the future.
Important: Before you begin, set the receiving phone to discoverable mode. You may also need to set it
to "Receive Beams" or "Receive Files." Refer to the phone’s documentation for instructions on receiving
information over Bluetooth.