Getting Started Guide

Section 1: Getting Started 15
1.4 Starting Up
Turning Your Device On and Off
To turn on your device, press and hold the Power Key at the right
side of the device. When you turn on your device for the first
time, a Quick Start Wizard will guide you through the calibration
process and the setup of regional settings, date and time, and
password. For more information about touch screen calibration,
see “Calibrating the Device.”
To turn off your device, press and hold the Power Key for a few
seconds. A message will then be displayed, prompting you
whether to turn off the device completely.
Switching to Sleep Mode
Quickly pressing the Power Key turns off the display temporarily
and switches your device to sleep mode. Sleep mode suspends
your device to a low power state while the display is off in order to
save battery power.
Your device also automatically goes into sleep mode when you
leave the device idle after a certain amount of time.
To specify the timeout period before your device goes into
sleep mode:
1. Tap Start > Settings > System tab > Power > Advanced
tab.
2. Under On battery power, make sure the Turn off device
if not used for check box is selected.
3. Select the battery timeout period, and then tap OK.
You will still be able to receive messages and calls while your
device is in sleep mode. Pressing the Power Key again or new
incoming calls/messages will wake up your device.
Calibrating the Device
Calibrating the device screen involves tapping the center of a
cross with the stylus as it moves around the screen. This process
ensures that when you tap the screen with your stylus, the tapped
item is activated.