User Manual

Getting Connected 89
• Configure your phone so that the Wi-Fi function turns off automatically
when no signal is detected to conserve battery power. In Comm Manager,
click Setttings > WLAN Settings > Wi-Fi > Menu > Wi-Fi Settings.
To create a new Wi-Fi connection
If the Wi-FI connection you want to connect to is not in the list, you can
create a new Wi-Fi connection. Before you start, make sure you have all the
relevant data about the Wi-Fi connection you want to connect to.
1. On the Home screen, click Start > Settings > Connections > WLAN
Settings > Wi-Fi > New.
2. Enter the Network name and Network type and click Next.
Note If you want only to connect directly to another device or computer, and not
to a network through an access point, select This is a device to device (ad-
hoc) connection.
3. Select the Authentication type and Data encryption then click
Next. For WPA authentication or TKP, AES, or WEP data encryption,
enter the needed information in the remaining fields.
4. Select Use IEEE 802.1x network access control to use Extensible
Authentication Protocol (EAP). Select the EAP type depending on the
type of authentication. Click Finish.
To increase security on the Wi-Fi network
The LEAP (Lightweight Extensible Authentication Protocol) feature of
Comm Manager helps increase security on your phone, and ensures that
nobody is able to access your network without your permission.
1. On the WLAN Settings screen, select LEAP.
2. Click Menu > New.
Note By default, the LEAP screen displays data that you entered previously.
However, you can modify or delete the data as required by clicking Menu >
Modify or Menu > Delete on the LEAP screen.
3. Enter the SSID (Service Set Identifier).