HTC Car Kit Installation Guide http://www.htc.com/www/support/warranty.
1 91H02046-02M Rev.
To ensure your safety on the road, please be careful when using your phone with the car kit while driving. Package content The following items come with your package. If any of them is damaged or missing, please contact your dealer. • • • • • Car holder Car charger micro-USB cable Dashboard disc Installation guide 3 1 91H02046-02M Rev.A第1台12頁金箭-9x9膠裝含封面116頁-百均 Thank you for purchasing the HTC Car Kit.
ENGLISH English About your car kit Mou Car holder base Base wheel You c either dashb Cradle Moun Suction pad tab To se follow Swivel neck 1 Pe 2 Pla suc 3 Pre the and clo bas pla micro-USB connector slot 24
heel You can mount the car holder either on your car windshield or dashboard. Mounting the car holder on the windshield ion tab neck To securely mount the car holder on the windshield, do the following: 1 Peel off the protective plastic sheet from the suction pad. 2 Place the car holder onto your windshield. Be sure that the suction pad tab is facing down. 3 Press the base firmly on the windshield. Then, turn and tighten the base wheel clockwise to make sure the base is securely locked in place.
ENGLISH English Mounting the car holder on the dashboard Adj To securely mount the car holder on the dashboard, do the following: Befo adjus prefe break Do not mount the car holder on the top of an air bag or within the working range of an airbag. 1 Remove the adhesive peel (if any) from the dashboard disc. 2 Attach the adhesive side of the dashboard disc on your dashboard. 3 Place the car holder on top Adju of the dashboard disc. Be sure that the suction pad tab is facing down.
hin disc. Before placing your phone on the cradle of the car holder, adjust the cradle first to the angle and orientation that you prefer. Refer to the following guidelines to avoid accidentally breaking or damaging the cradle. When adjusting the cradle, DO NOT exceed the maximum tilt or rotate angle. If the cradle stops in the direction where you are rotating or tilting it, DO NOT force it further to avoid damage or breakage.
ENGLISH English Adjusting the cradle Doc Rotate the cradle gently to adjust it to an upright or horizontal orientation so that it can hold your phone in vertical or in horizontal position. Adjust cradle to horizontal orientation will automatically rotate Car UI to landscape mode. Place align micro Atta hold Plug micro cradl you h To d Press slot.
Docking your phone on the cradle Place your phone inside the cradle and align your phone USB connector with the micro-USB connector slot of the cradle. Attaching the USB cable on the cradle of the car holder Plug the supplied USB cable to the micro-USB connector slot of the cradle. Be sure to push it fully until you hear a clicking sound. To detach the USB cable: Press both sides of the clip to release it from the slot.
ENGLISH English Unm To adjust the USB cable length: Wrap the cable around the swivel neck and route it through the suction pad tab. Position it where it does not block your vision when driving. 1 Re cra 2 Tu cou the 3 Pu and win Charging your phone with the car charger When your phone battery runs low, you can use the supplied car charger to charge the battery. 1 Place your phone inside the cradle and connect it with USB cable. 2 Connect the other end of the USB cable to the car charger.
1 Remove your phone from the cradle of the car holder. 2 Turn the base wheel counter-clockwise to release the car holder base. 3 Pull the tab on the suction pad and detach the car holder from the windshield or dashboard disc. plied available Taking care of your car kit • Remove your phone from the cradle of the car holder when you leave the car to avoid prolonged exposure to heat. • Do not force if the cradle stops in the direction you are rotating or tilting it further to avoid damage.
ENGLISH English Safety guidelines Übe 1 Before you start driving, follow these steps: Vielen haben Diese bedien • Place and adjust the cradle position so that it does not block your vision when driving. • Do not install the car kit on the top of an airbag or within the working range of an airbag. • If you plan to charge your battery with the car charger, be sure to adjust the USB cable length properly and position it where it does not block your vision when driving.
91H02285-00M Rev.
