User Manual

HT211
EN - 12
5.6. CAPACITANCE MEASUREMENT
CAUTION
Before taking capacitance measurement in circuit remove power from the
circuit being tested and discharge all capacitors. Connect the test capacitor
to the inputs respecting the polarity connections when required.
Fig. 7: Using the instrument for Capacitance measurement
1. Switch on

2. Press the MODE key until the “nF” symbol is shown at display
3. Insert the test leads into the jacks, the red plug into mAµAVHz% jack and
black plug into COM jack
4. Connect the red and black test clamps to the capacitor terminals respecting if
necessary the proper polarities (see Fig. 7). The capacitance value is shown on display
5. If the message "O.L" is displayed the higher range is reached
6. For HOLD function refer to § 4.2