Manual

GSC53N - GSC57 - ZG47
EN - 71
1
st
Page of the RECORDER
CONFIG MENU
2
nd
Page of the RECORDER
CONFIG MENU
NOTE: The Selected Instrument's Input must comply with the "enabled" input in the real
time measurement (see par 7.1). So for example if the In3 (Input 3) is disabled in
real time measurement , it can't be selected for recording. In case of mistake the
instrument will not allow to start a recording showing the message "Selection error".
Symbols
Description
Advised settings
START:MAN
The recording of all the selected parameters will start at 00
seconds after pressing START/STOP (see chapter 7).

STOP:MAN
The recording of all the selected parameters will be interrupted
manually by pressing START/STOP (see chapter 9).

START:AUTO
STOP:AUTO
The recording of all the selected values will be started / interrupted
at the set dates and times. In order to start the recording the user
will have to press START/STOP to set the instrument in Stand-by
mode until the start date and time previously set (see chapter 7).
INT. PERIOD
The value of this parameter determines every how many seconds
the values of all the selected parameters will be memorised
(see chapter 16.4.1). Available choices:
5sec,10sec,30sec,1min, 2min 5min, 10min, 15min, 30min, 60min.
15min

IN1, IN2, IN3
Value of the Instrument's input In1, In2, In3 respectively.

IN1, IN2, IN3
For eventual messages displayed see Appendix 1 – MESSAGES DISPLAYED
RECORDER CONFIG
START
MANU
STOP
MANU
INT. PERIOD: 15min
+
-
ENTER

Use the keys F1, F2 to position the
cursor on the desired word and use
the keys F3 / F4 to modify the
value.
Press ENTER to confirm and
proceed inside the Menu the Menu
keeping the settings made.
Press ESC to leave the Menu
without modifying the existing
parameters.
MENU

To Select MANUAL or AUTOMATIC
start/stop mode, place the cursor on
MANU or AUTO using the key F1 or
F2 and select the desired mode using
F3 or F4.
Use the keys F1, F2 to position the
cursor on the desired Input Signal
and use the keys F3 / F4 to select /
deselect the desired parameter (it’s
selected if marked in black).
Press ENTER to confirm and leave
the Menu keeping the settings
made.
Press ESC to leave the Menu
without modifying the existing
parameters.
RECORDER CONFIG
AUXILIARY INPUT:
IN1 IN2 IN3
+
-