Manual

GSC53N - GSC57 - ZG47
EN - 70
7.2. ENVIRONMENTAL PARAMETER AND LEAKAGE CURRENT: RECORDING
Before starting a recording we recommend You to check that real time values are correct.
To this purpose follow the measurement procedure described in paragraph 7.1.
in addition it's fundamental that Instrument settings correspond to the accessories is use.
For this we recommend you to check instrument's setting before execute an AUX
recording.
To this purpose please check the RECORDER CONFIG settings.
 MENU: to enter in the MENU mode and change the instrument settings. It’s
not possible to enter the configuration MENU during a recording or an
energy measurement.
 START/STOP: to record the selected parameters according to the instrument’s
settings (see chapter 10).
7.2.1. AUX Basic setting: RECORDER CONFIG
Place the rotary switch in the AUX position, press the MENU key, using the F1/F2 keys
select the RECORDER CONFIG item and press the ENTER Key.
WARNING
It’s not possible to enter the MENU during a recording or a Real Time
Energy measurement.
MENU GENERAL
SAFETY TEST MEMORY
ANALYSER MEMORY
RESET
ANALYSER CONFIG
RECORDER CONFIG
CONTRAST
DATE&TIME
LANGUAGE
This option allows you to check and eventually modify the recording parameters and the
selected parameters (up to a maximum of 3). The RECORDER CONFIG mode is divided
into 2 separate sub-pages:
 1
st
page: This page allows you to set the START/ STOP mode (AUTO or
MANUAL), the START and STOP time (if AUTO mode is selected) and
the Integration Period value. Press ENTER to confirm the settings and
pass to the following page.
Press ESC to leave the Menu without modifying the existing parameters.
 2
nd
page: This page allows the selection of the Input channels to be recorded.
Press ENTER to confirm the settings and leave the RECODER CONFIG
Menu. Press ESC to leave this page without modifying the existing
parameters.
The various pages of the "RECORDER CONFIG" can be schematised as follows: