Manual
GSC53N - GSC57 - ZG47
EN - 4
1. SAFETY PRECAUTIONS AND PROCEDURES
1.1. GENERAL
This apparatus conforms with safety standards EN61557 and EN61010-1 relating to
electronic measuring instruments.
WARNING
For your own safety as well as that of the apparatus you are recommended
to follow the procedures described in this instruction manual and carefully
read all the notes preceded by the symbol .
Strictly keep to the following instructions before and during measurements:
Do not take measurements in wet environments or dusty places.
Do not effect measurements in environments with explosive gas, fuels.
Keep you insulated from the object under test waiting for measuring.
Avoid any contact with exposed metal parts, ends of test leads not in use, circuits, etc.
Do not effect any measurement in case of unusual conditions of the instrument such as
deformation, breakage, leakage of substances, absence of display reading etc.
Do not use the External power supply adapter (code A0050, optional for GSC57) if you
notice deformation, or breakage in the case, in the wire or in the plugs.
Pay careful attention when measuring voltages exceeding 25V in particular places
(building yards, swimming pools, etc.) and 50V in ordinary places because of the risk of
electric shock.
Use only cables and accessories approved by HT ITALIA.
The following symbols are used in this manual:
Caution: refer to the instructions reported on this manual; improper use may
damage the apparatus or its components.
AC Voltage or Current.
Unidirectional pulsating Voltage or Current.
Rotary switch of the instrument.
1.2. PRELIMINARY INSTRUCTION
This instrument has been designed for use in environments with a pollution level 2 and
up to (and no more than) 2000 meters altitude.
It can be used for Safety Test on Installation with Overvoltage Category III 300V~
(phase to earth) and for voltage and current measurements on installations with
overvoltage category III 600 V~ phase to phase / 300 V~ phase to earth or CATII 350 V
phase to earth.