User guide

T2000-T2100
EN – 21
4. (T2100 only) Press and hold the
multifunction key “1” for more than 2
seconds to show the value of the parallel
resistance calculated basing on all the
results saved in the instrument’s memory
- see 4.5.3.1 (indicated by “PA” symbol
on LCD). Shortly press the multifunction
keys “2” ( function) or “3” ( function) to
quit this mode and go back to the results
stored.
Fig. 36
4.8.3. Deleting the last datum saved
1. Press and hold the multifunction key “1” for more than 2 seconds to switch on the
instrument
2. Shortly press the multifunction key “1” repeatedly until accessing the memory area
(RECALL function). The instrument displays the last datum saved in the memory and
symbols + (see Fig. 34)
3. Press and hold the multifunction key “2” for
more than 2 seconds (CLEAR LAST
function) to delete the last datum saved in
the memory. The screen in Fig. 37 will
appear, with “CLr” flashing; to confirm data
deletion, shortly press the multifunction key
“2”.
Fig. 37
4.8.4. Deletion of all saved data
With the clamp OFF, contemporarily press
and hold the multifunction keys “1” and “2”
(CLEAR ALL function) for more than 2
seconds. The screen in Fig. 38 will be
shown for a few seconds, to confirm that the
memory has been completely cleared.
Then, the clamp will switch on as described
in § 4.4.
Fig. 38