Instruction Manual
HT326
EN - 12
4.3.6. Continuity test
CAUTION
Before taking resistance measurements on the circuit remove power from
the circuit being tested and discharge all capacitors.
Fig. 7: Using the instrument for Continuity test
1. Selecting the position
2. Insert the test leads into the jacks, the red plug into VHz
jack and black plug
into COM jack
3. Connect the test leads to the circuit under test (see Fig. 7)
4. The resistance value is displayed and the instrument emits a sound signal if the
resistance value results to be <140
5. The message "
O.L." on the display indicates that the resistance value is higher than
400.
CAUTION
The displayed value is just indicative and does not correspond to the
resistance value.