Operating instructions

english
english
16 Classic 411.2 OMDD 10/2011
Bag for shredded material full
 Red LED on membrane key-
board lights.
 Shredder stops automatically.
Notice Empty the cut material container,
immediately because if it is too full, malfunc-
tions can occur in the cutting system.
Note Reversing the cutting device
(“Reverse” button) is also possible even
when the shredded material container is full.
• Insert new bag.
Switch off the shredder and pull out the
mains plug. When cleaning only use a soft
cloth and a mild soap-water solution. How-
ever, no water must enter the equipment.
Oil the cutting unit when
cutting performance de-
creases or the device
becomes noisy, or every
time you empty the waste
container:
• Spray special cutting block oil
across the whole width of the cut-
ting system blades.
• Run cutting system forwards and
backwards several times without
feeding CD/DVD.
 Dust and particles are shaken off.
8 Cleaning and maintenance
For all other malfunctions, before calling
customer service please check
– if the motor was overloaded
Let the shredder cool down for approx.
15 – 20 mins. before using it again.
– if the light barrier is soiled.
Clean the light barrier in the feed using a
dry brush or cloth.
9 Disposal / Recycling
Electrical and electronic old de-
vices contain a variety of valuable
materials, but also hazardous
substances which were required
for function and safety. Incorrect
disposal or handling can be dan-
gerous to your health and the environment.
Never dispose of old devices in the house-
hold waste. Observe the current applicable
regulations and use the collection points for
returning and recycling electric and elec-
tronic devices. Dispose of all the packaging
materials also in an environmentally-respon-
sible way.