Operating instructions

english
english
10/2011 Classic 411.2 OMDD 15
Swit ching shredder off
• Set mains switch at rear of the
shredder to „0“.
0
I
The shredder can also be started
by pressing the green arrow but-
ton:
• Press briefl y:
Cutting device starts.
Automatic stop approx. 3 seconds
after the last CD was drawn in, or
manual stop when the stop button
is pressed.
• Hold down for longer than
2 seconds:
constant operation without light
barrier function.
The cutting device runs until it is
switched off with the stop button.
Jam
 Shredder jammed.
 Red LED in the key pad fl ashes.
 Shredder reverses automatically.
Notice!
Do not press dashed arrow button and
green arrow button alternately forwards and
backwards. Cutting unit can be damaged.
• Pull CD out of the feeding open-
ing.
If CD is not completely pushed out,
then
• Press dashed arrow button.
 CD is pushed out.
• Feed only one CD/DVD.
Electric motor overheated
 Red LED on membrane key-
board lights.
 Shredder switches off automati-
cally.
• Allow shredder to cool down for
approx. 15 to 20 min.
Front door is open
 Red LED on membrane key-
board lights.
 Shredder stops automatically.
• Close front door.
Note If the door is opened when
the cutting device is running, the shredder
must be started again using the green but-
ton after the door of the shredder has been
closed.
7 Troubleshooting