manual

7
Remark:
1. In case of you did not stop the search on time when device reacted, you
may press the or key to search back to find the passed code.
2.The keys of OK, EXIT are only used to set-up your new remote
control during the Auto Search, you can’t control your device for menu
function at the moment until you quit from the set up .
3. When remote control searches through all codes, the remote control will
stop at the beginning code of the search.
4. If the device is locked, you must first unlock the device then set up.
Set-up by Enter Code
1. Switch on the device, which you would like to control (e.g. TV, DVD…).
2. In the back section of this manual, please find the brand name and code no
of your device brand (e.g. Lifetec 003,010,062,).
3. Press the SET key on your new remote control for more than 3 seconds,
then release it.
4. Press the or keys to select to SetupCode in LCD menu, and
press the OK key.
5. Press the or keys to select to EnterCode in LCD menu, and
press the OK key.
6. Then you press device key to select your desired operation device(e.g. TV,
DVD…) and then press the OK key, you must now enter the 3-digit device
code (e.g. 003 for Lifetec TV).
7. Press the OK key to save it and LCD shows Success!, and press EXIT key
two times to exit the SETUP mode.
8. Please you check the function of the keys on remote control. If most of keys
on your new remote control do not function correctly, please try to another 3-
digit device code (e.g. 010…) from the code list under the same brand. Then
repeat steps 3 to 7 until all the basic functions operate correctly. You can
press device key (e.g. TV) again to finish SET UP or use or to
select other set up.