manual

4
Note: Before you set up any function, you must activate the RC UNIVERS47
on first by touching the screen or pressing any key on the remote control.
Battery Installation
This remote control needs 4 batteries to work with. please refer to the
direction marks inside the battery apartment and please put 4 pieces of fresh
AAA in the battery apartment. Alkaline batteries are recommended since it has
a large LCD screen to run out of more power consumption than the common
universal remote control.
To install the batteries:
1. Turn the remote over, pull up on the tap and lift the cover off.
2. Insert the batteries matching the batteries to the (+) and (-) marks
inside the battery case.
3. Slide the battery cover back into the place.
Note: Whenever the batteries need replacement, the LCD remote will indicate
with battery low message. Please replace them with new batteries now. All
settings you have programmed into the new remote control will be stored in
memory even if you take off the batteries (but you may need to reset the clock).
Device Edit
Adding a Device
If you want to operate the second TV (or second VCR, DVB, DVD, CD,
TAPE, TUNER etc.), you can add a new device. Please just operate the steps
following:
1. Press the SET key on your remote control for more than 3 seconds, then
release it.
2. Press the or keys to select to Device in LCD menu, and press
the OK key.
3. Press the or keys to select to Add New in the LCD menu, and
press the OK key, the LCD shows SelectDEV, then please you press device
key to select your desired adding device (e.g. TV or DVD …). If you add more
than 8 new devices, the LCD will shows Full.
4. Press the OK key to save it and LCD shows Success!.
5. If you add other devices please repeat steps 3~5. You can press device key
(e.g. TV) again to finish SET UP or use or to select other set up.