manual

3
Operation
Always turn off the connected device prior to connecting/
disconnecting it to the output of the cigarette lighter.
1. Start the car engine. Ensure that the total power needed for the
connected device does not exceed the maximum output of the
converter.
2. Put the converter in the cigarette lighter, which has an output
voltage of 12-13.8V. When the green led is lit up, the converter is
ready to be used.
3. Connect the device you want to use to the converter. Ensure
that the current consumption of the electrical device is lower than
75W.
4. Turn on the electrical device.
Troubleshooting:
When the converter does not work properly it can be for several
different reasons:
1) Bad connection
• Thoroughly clean the contacts
2) The converter does not get voltage
• Check the relevant fuse in the car, replace the potentially broken
fuse
• Check the wire connections
3) Blown fuse
• The fuse is located in the DC (cigarette lighter) plug. Replace the
fuse with a similar fuse of the same strength.