Specifications

VDP2301RGVLD10 - VDP2601RGYLD10 - VDP3801RGVLD10
11/08/2011 ©Velleman nv
6
simultaneously. If you set different addresses, each device will “listen” to a separate channel number.
Changing the settings of one channel will only affect the device in question.
In the case of the 10-channel laser projector, you will have to set the start address of the first laser
projector to 1, the second laser projector to 11 (10 + 1), the third to 21 (10 + 11) and so on.
• DMX5 channel assignment
Channel DMX512
value
function
1 control mode
0--63 Sound control (channel 3~10 not used)
64--127 Auto mode (channel 3~10 not used)
128--191 DMX control
192--255 Auto mode
2 blanking & blackout
VDP2301RGVLD10
VDP3801RGVLD10
VDP2601RGYLD10
0--5 blackout blackout
6--10 white
red
11--15 red
16--25 yellow
green
21--25 green
26--30 cyan
yellow
31--35 blue
36--40 purple 36--105 single colour (auto)
41--110 single colour (auto) 106--175 tri-colour (auto)
111--180 multi-colour (auto) 176--245 tri-colour (move)
181--251 multi-colour (move) 246--255 bounded colour
251--255 bounded colour
3 pattern 0--255 124 patterns (0-255)
4 vertical move
0--127 manual vertical move
128--191 auto down, speed up accordingly
192--255 auto up, speed up accordingly
5 horizontal move
0-127 manual horizontal move
128--191 manual right, speed up accordingly
192-255 manual left, speed up accordingly
6 vertical roll
0--127 manual vertical rotation
128--255 auto vertical rotation, speed up accordingly
7 horizontal roll
0--127 manual horizontal rotation
128--255 auto horizontal rotation
8 rotation
0--127 manual rotation
128--191 auto clockwise rotation, speed up accordingly
192--255 auto anti-clockwise rotation, speed up accordingly
9 zoom in & out
0--85 from small to large, speed up accordingly
86--170 from large to small, speed up accordingly
171--255
large ←→ small, speed up accordingly
10 point draw 0--255 0=nil / 1~255=faint ~bright
6.2 SD Card controlled mode
• Press the SD CARD mode switch [6] to select SD CARD controlled mode.
• In SD CARD mode, a DMX address (and thus a controller) is still required.
SD card notes:
• Only use high quality SD cards of well known brands to avoid reading errors.
• Max. supported capacity = 2GB.
• The card must be formatted as FAT16 file system. The card that comes with the device is already correctly
formatted.
• Do not place files in sub-directories.
• Do not place more than 260 files in the root directory.
• File name length is limited to 8 characters (followed by the .ild extension).
• 5animated) files (shows) must be created using an appropriate ILDA software program (not included).
• The root directory may contain 3 reserved files. Do not remove these files:
o CONFIG.DAT: contains setting information for the laser projector. See further for instructions on creating
and modifying this file.
o FLASHMP.BIN: control program for firmware updates