Quick Start Guide

HPRT M11
Product Introduction
LED Indicator Status
Red LED Error Status
Basic Status
ON: Charging finished/Printer is ready
Slow Flash: Charging
ON: Error (Paper jam/Paper end/Cover opened)
Slow Flash: Low power
Quick Flash: TPH is over temperature
Green LED
Red and green LED flash alternately
Hold down the power button for a few seconds: Turn on/off the printer
Press the power button: Position and calibrate the location of thermal label paper
and heating line
Button Operation
Firmware updating
Paper Loading
Slide the cover-opening
button as shown in the
figure to open the upper
cover.
Load the paper as shown
in the figure and make sure
the thermosensitive layer
faces down.
Thermosensitive
Layer
Close the upper cover and
pull some extra paper.
Edit the label as need, and then click “Print” after
editing.
Connection and Printing
Turn on Bluetooth on your mobile phone, then open
App, click “Device Connection”, select “ HPRT M11”.
Select “Scan to get the template”, then scan the QR
code on the paper core to recharge consumables
mileage and get the templates.
App Download
Scan the QR code to download App.
Product Introduction
Appearance and Components
Cover-opening
Button
USB Interface
Power Button &
LED Indicator
Packing List
Quick Start Guide
USB Cable
Printer
Paper Outlet
Tear Bar
When the battery power is low, the red LED indicator will flash slowly.
Please charge it by the exclusive USB cable in time. If you continue printing，
it may power off automatically.
Battery Charging
Note: The printer can be charged via computer USB port or AC adapter.
Please note that the AC adapter is not supplied.
Charge via PC
Charge via AC Adapter
When the printer crashes, how to deal with it?
Open the upper cover, lightly hold down the [Reset] button with
a pin so that the printer will be off, and then restart the printer.
General Q&A FCC WARNING
Reset
Button
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device
can be used in portable exposure condition without restriction.
FCC ID：2AUTE-PLP