User's Manual

HM-E300 User Manual
13
Example
When you want to change the settings of the printer mode as shown below,
Item
Factory Setting
Configuration Example
1 Density
0(Medium)
1(Low)
2 Standby Time
0060(Sec)
0080(Sec)
3 Auto Off Time
0120(Min)
1120(Min)
4 Paper Type
0(Receipt)
2(BM(2inch))
5 Language
0(EN)
1(CH)
6 Factory Reset
0(N)
1(Y)
Press and hold the MODE & FEED buttons for 5 seconds.
→
You will see present “Enter Menu Mode” in the LCD.
Press the MODE button once to switch the menu item.
Display: 1 Self Test →2 System Setting
→
Press and hold the FEED button for 2 seconds to get into the menu.
Display:
1 Density
2 Standby Time
3 Auto Off Time
4 Paper Type
5 Language
6 Factory Reset
7 Prior Menu
 Press MODE button to switch the menu item, then press the FEED button once to enter the menu.
→Press the FEED button once to get into the Density menu.
Display:
Density:
0-Low 1-Medium
2-High 1
3-Special
→
Press the MODE button once to input the number 1, then press and hold FEED button to confirm the
new setting and return to the previous menu.
1(Medium) → 2(High)
Please use at a room temperature if you want to set the density to ‘3 Special’.
Some type of the paper are not suitable for use in low temperature environment.