Line Interactive Rack/Tower Uninterruptible Power System

QuickSpecs
HPE Rackmount UPSs
Specifications
Page 9
HPE R/T2200 Uninterruptible Power System (UPS)
NA/JPN rear panel
1
USB communication port
7a
Group 1: Two programmable outlets for connection of
equipment
2
RS
-232 communication port 7b
Group 2: Two programmable outlets for connection of
equipment
3
Connector for automatic recognition of an additional battery
module
8
Primary Group: outlets for
connection of critical equipment
4
Slot for optional communication card, shown with optional
Management Card
installed
9
Attached input power cord for AC power source
5
Connector for ROO (Remote On/Off) or RPO (Remote Power
Off) control
10
LED indicating SWF (site wiring fault) alarm (Although the
LED remains on the rear panel, this feature is disabled for
low voltage models)
6
Connector for additional battery module
11
Ground connection
R/T2200 and R/T3000 UPS Specifications
Electrical Input
Voltage Range
100V nominal = 80V – 128V
120V nominal = 89V – 159V
208V nominal = 160V – 163V
230V nominal = 160V – 294V
See Model Matrix for nominal and user selectable voltage settings.
Frequency
50/60 Hz
Online Efficiency
94%
Electrical Output
On battery Regulation
±5% of nominal voltage
Online Regulation
-10% to +6% of nominal voltage
Voltage Wave Form
Sine wave
Connections
See Model Selection Matrix; divided into 2 Load Segments
Output protection
Firmware overload sensing and control
Battery
Type
Extended Batteries
Up to four ERMs can be supported; recommendation is up to 2
Backup Time
See Backup Times Chart
Recharge Time
<3 hours to 90% usable capacity; <24 hours for complete recharge
Voltage
R/T2200 = 48V
R/T3000 = 72V
Communications
Serial Ports
Standard DB-9 and USB ports (ships with communication cables)
Option Slot
(1) (For optional Communication Card)
1
2
3
4
5
6
7a
11
8
9
10
7b