User Manual

CAUTION:
THE CONTACTS ARE VERY FRAGILE AND EASILY DAMAGED. To avoid damage to the socket
or processor, do not touch the contacts.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
• Extend the server from the rack.
• Remove the server from the rack.
5. Remove the access panel.
6. Do one of the following:
• Remove the air baffle.
• If installed, remove the 4LFF midplane drive cage.
7. Install the processor heatsink assembly:
a. Remove the dust cover.
b. Locate the Pin 1 indicator on the processor frame and the socket.
c. Align the processor heatsink assembly with the alignment pins and gently lower it down until it sits
evenly on the socket.
The heatsink alignment pins are keyed. The processor will only install one way.
A standard heatsink is shown. Your heatsink might look different.
d. Using a T-30 Torx screwdriver, tighten the nuts until they stop.
Hardware options installation 111