Specifications

Table 4-1 Computer Setup (F10) Utility menu descriptions (continued)
Heading Option Description
Default Setup Provides these options:
●
Save Current Settings as Default—Saves the current settings as default settings for the next
operation.
●
Restore Factory Settings as Default—Restores the factory settings as the default settings for the
next operation.
Apply Defaults
and Exit
Restores the default settings defined in Default Setup.
Ignore Changes
and Exit
Exits workstation setup without applying or saving changes.
Save Changes
and Exit
Saves changes to system configuration and exits the workstation setup.
Storage Device
Configuration
Lists installed non-SCSI storage devices (except SATA devices) and provides options for obtaining
specific information about each device:
●
Hard Disk—Provides information about the hard disk drives in the workstation. It is available
in IDE Mode only.
●
CD-ROM—Provides information about the optical disk drives in the workstation. (IDE mode
only.)
●
Diskette Type (for legacy diskette drives only)—Identifies the highest capacity media type
accepted by the diskette drive. Options are 3.5" (1.44 MB), 5.25" (1.2 MB), and Not
Installed.
●
Default Values—Resets devices to their default configuration (SATA is the default).
◦
Multisector Transfers—Defines the transfer of data per interrupt. Options are 8, 16, and
Disable (16 is the default).
◦
Transfer Mode—Specifies the active data transfer mode. Options (subject to device
capabilities) are Max UDMA, PIO 0, Max PIO, Enhanced DMA, and Ultra DMA0.
(Max UDMA is the default).
◦
Translation Mode—Lets the BIOS determine the translation mode used to configure a
formatted SATA or USB mass storage device. This prevents you from needing to know
how the mass storage device was formatted. Options are Automatic, Bit Shift, LBA
Assisted, Use (Cylinders, Heads, Sectors), and Off. Automatic is the default.
Ordinarily, you should not change the translation mode selected by the BIOS. If the
selected translation mode is not compatible with the translation mode that was active
when the drive was partitioned and formatted, the data on the disk is inaccessible.
ENWW
The Computer Setup (F10) Utility
35