User guide

Table 2-1 Computer Setup (F10) Utility menu descriptions for the HP Z220 SFF and Z220 CMT
Workstations (continued)
Heading Option Description
NOTE: If you turn off power to the computer using a power strip, you
cannot use the suspend/sleep feature or the Remote Management
features.
●
POST Delay (None (default), 5, 10, 15, 20 seconds)—Delays start of the
POST process. You might need a delay to:
◦
Allow time for some hard disk drives to spin up before POST is finished.
◦
Give yourself more time to select F10 to enter Computer Setup (F10)
Utility.
●
Remote Wakeup Boot Source (Local Hard Drive/Remote Server). Sets the boot
device for the workstation when it is started using Remote Wakeup (takes
precedence over the Boot Order menu setting).
●
Bypass F1 Prompt on Confirmation Changes (Enabled/Disabled)—Prevents
display of a confirmation prompt when you make changes to the system.
●
Factory Recovery Boot Support—Enable/Disable
●
POST Memory Manager Runtime Allocation—Enable/Disable
BIOS Power-On Lets you disable or specify a weekday and time for BIOS power-on.
Onboard Devices Lets you disable or set resources (IRQ, DMA, I/O Range) for onboard system
devices such as the serial port and parallel ports. Operating system parameters
generally override Onboard Devices settings.
Bus options Enable/disable these options:
●
PCI SERR# Generation (Enabled/Disabled)—Controls PCI SERR# generation
for ill-behaved PCI add-in cards (that can generate SERR# spuriously).
●
PCI VGA Palette Snooping (Disabled/Enabled)—Controls PCI VGA Palette
Snooping for compatibility purposes.
●
PCI Latency Timer (32/64/96/128/160/192/224/248). 128 PCI Clocks is
the default.
●
Legacy ACPI CPU Tables—Support for legacy operating systems
50 Chapter 2 System management