Specifications

5. Push down on the expansion card retention clamp levers on the inside of the chassis to open the
retention clamp (1) as shown below.
Figure 5-31 Removing the expansion card
6. If the card is in one of the slots with a latch, release the latch (2). (Note that there are two different
styles of latch.)
7. Carefully lift the card from the chassis (3).
8. If you are not replacing the card in this slot, install an expansion slot cover and close the expansion
card retention clamp.
If the expansion card retention clamp does not close, ensure that all cards are properly seated,
and then try again.
ENWW Removing and installing components 101