Specifications

Rear system fan assembly
This section describes how to remove and install the rear system fan assembly.
Removing the rear system fan assembly
To remove the rear system fan assembly:
1. Disconnect power from the computer (see
Predisassembly procedures on page 70).
2. Remove the side access panel (see
Removing the side access panel on page 73).
3. Disconnect the rear system fan assembly cable (1) from the system board as shown in the following
figure.
Figure 5-24 Disconnecting fan wires
4. Remove the four screws from the rear of the chassis (2), and then pull the fan assembly inward
and then up (3) out of the chassis.
Installing the rear system fan assembly
To install the rear system fan assembly, reverse these steps.
ENWW Removing and installing components 91