Specifications

Speaker
This section describes how to remove and install the speaker.
Removing the speaker
To remove the speaker:
1. Disconnect power from the computer (see
Predisassembly procedures on page 70).
2. Remove the side access panel (see
Removing the side access panel on page 73).
3. Remove the front bezel (see
Removing the front bezel on page 76).
4. Disconnect the speaker cable from the system board (1) as shown in the figure below.
5. Remove the two screws as shown (2).
6. Slide the speaker away from the chassis and remove it from the chassis (3).
Figure 5-21 Removing the computer speaker
Installing the speaker
To install the speaker, reverse the previous steps.
88 Chapter 5 Replacing components ENWW