User Manual

Removing the display stand
You can remove the display panel from the stand to install the panel on a wall, a swing arm, or other
mounting xture.
CAUTION: Before beginning to disassemble the display, be sure the display is turned o and all cables are
disconnected.
1. Disconnect and remove all cables from the display.
2. Lay the display face down on a at surface covered by a clean, dry cloth.
3. Push up on the latch near the bottom center of the display to unlock the HP Quick Release 2 (1).
4. Swing the bottom of the stand up until the mounting plate clears the recess in the panel (2).
5. Slide the stand out of the recess (3).
Mounting the display
The display panel can be attached to a wall, swing arm, or other mounting xture.
NOTE: This apparatus is intended to be supported by UL or CSA Listed wall mount bracket.
CAUTION: This display supports the VESA industry standard 100 mm mounting holes. To attach a third-
party mounting solution to the display, four 4 mm, 0.7 pitch, and 10 mm long screws are required. Longer
screws must not be used because they may damage the display. It is important to verify that the
manufacturer’s mounting solution is compliant with the VESA standard and is rated to support the weight of
the display panel. For best performance, it is important to use the power and video cables provided with the
display.
Mounting the display to a xture
To mount the display panel to a mounting xture:
1. Remove the display from the stand. Removing the display stand on page 17.
Removing the display stand 17