User Manual

Connecting the cables
NOTE: The display ships with select cables. Not all cables shown in this section are included with the
display.
1. Place the display in a convenient, well-ventilated location near the computer.
2. Before connecting the cables, route the cables through the cable routing hole in the center of the stand.
3. Connect a video cable.
NOTE: The display will automatically determine which inputs have valid video signals. The inputs can
be selected by pressing the Next Input button on the front panel or through the On-screen display (OSD)
by pressing the Menu button and selecting Input Control.
●
Connect one end of a DVI-D cable to the DVI-D connector on the rear of the display and the other
end to the DVI-D connector on the source device.
8 Chapter 3 Setting up the display