User Manual
3 Setting up the display
To set up the display, ensure that the power is turned o to the display, computer system, and other attached
devices, then follow the instructions below.
NOTE: Be sure the master power switch, located on the rear panel of the display, is in the o position. The
master power switch turns o all power to the display.
Use caution when setting up the display
To prevent damage to the display, do not touch the surface of the LCD panel. Pressure on the panel may cause
nonuniformity of color or disorientation of the liquid crystals. If this occurs the screen will not recover to its
normal condition.
If installing a stand, lay the display facedown on a at surface covered with a protective sheet foam or a non-
abrasive cloth. This prevents the screen from getting scratched, defaced, or broken and prevents damage to
the front panel buttons.
NOTE: Your display may look dierent from the display in this illustration.
Use caution when setting up the display 5