System information

5–30 338611-001 Service and Technical Reference Guide, xw3100

Removal and Replacement Procedures

5.16 Speaker

To install the speaker:

1. Prepare the workstation for disassembly (Section 5.1).

2. Remove the workstation access panel (Section 5.5).

3. Rotate the drive cage to its upright position.

4. Remove the expansion card cage (Section 5.9).

5. Disconnect the speaker wire from the system board.

6. Carefully cut the cable tie that secures the speaker cable to the power supply cable bundle.

CAUTION: Be careful when cutting the cable tie not to cut any cables.

7. Remove the power supply from the chassis (Section 5.17).

8. Remove the two screws that secure the speaker to the chassis.

9. Slide the speaker towards the rear of the chassis and down to remove it.

To install the speaker, reverse the removal procedures.

Sound power level LWAd (B)

Operation: Hard Drive/48X CD-ROM 4.2/5.4 Bels

Stand-by/Idle: 3.9 Bels

Sound pressure level dB

Operation: Hard Drive/48X CD-ROM 29/44 dBA

Stand-by/Idle: 26 dBA