System information

Service and Technical Reference Guide, xw3100 338611-001 5–17

Removal and Replacement Procedures

8. Push the drive release latch 1 toward the rear of the chassis and hold.

9. Slide the drive 2 toward the front of the drive cage, then lift the drive out of the workstation.

To replace the drive:

1. Install two guide screws in the lower holes on each side of the drive.

CAUTION: Use only 3/16-inch or 5-mm long screws as guide screws. Longer screws can damage the

internal components of the drive.

✎

When replacing the drive, transfer the four screws from the old drive to the new one. The screws

take the place of drive rails. You will need a Torx T-15 screwdriver to remove and re-install the

guide screws.