System information

5–10 338611-001 Service and Technical Reference Guide, xw3100
Removal and Replacement Procedures
The workstation automatically recognizes the additional memory when the workstation is turned
on.
To reassemble the workstation, reverse the removal procedure.
✎
If you normally lock the Smart Cover Lock, use Computer Setup to relock the lock and enable
the Smart Cover Sensor.
For technical information on memory modules, refer to Appendix F, “Memory.”
5.9 Expansion Card Cage
1. If you have locked the Smart Cover Lock, use Computer Setup to unlock the lock
(Section
5.2).
2. Prepare the workstation for disassembly (Section 5.1).
3. Remove the workstation access panel (Section 5.5).
4. Disconnect all cables attached to the expansion cards.
5. Grasp the expansion card cage by the green labels (the cage in the workstation has two spots
marked 1) and pull it straight up from the chassis.
To install the card cage, reverse the removal procedures.