Specifications

3. If you are installing a new DX115 unit, remove and discard the counter-sunk shipping screw on
the side of the DX115 case.
Figure 5-32 Removing the shipping screw
4. Install four (supplied) M3 x 5mm screws (black) in the lower four mounting holes of the DX115
case. (See
Locating extra guide screws on page 72 for screw locations.)
Figure 5-33 Installing the guide screws
5. Position the guide screws on the drive into the J-slots in the drive bay. Then slide the drive toward
the front of the computer until it locks into place.
Figure 5-34 Installing the DX115 unit
86 Chapter 5 Replacing components ENWW