Specifications

Table 5-4 Drive positions (continued)
3 5.25-inch external drive bay for optional drives (optical drive shown)
NOTE: The drive configuration on your computer may differ from the drives shown above.
NOTE: You can install a maximum of two hard disk drives in the Z210 SFF.
NOTE: For additional information about configuring SATA RAID devices, see
Configuring RAID devices on page 163.
Remove bezel blanks
On some models, you may need to remove the bezel blanks that cover the 3.5-inch and 5.25-inch drive
bays before you install a drive. To remove a bezel blank:
1. Remove the access panel (see
Removing the access panel on page 64).
2. Remove the front bezel (see
Removing the access panel on page 64).
3. On the inside of the bezel, push the two retaining tabs that hold the bezel blank in place towards
the outer right edge of the bezel (1), then slide the bezel blank back and to the left to remove it
(2).
70 Chapter 5 Replacing components ENWW