Specifications

Access panel sensor (optional)

The access panel sensor is a remote solenoid that detects when the access panel is opened. This section

describes how to remove and install the sensor.

Removing the access panel sensor

To remove the access panel sensor:

1. Prepare the computer for servicing by following the

Predisassembly procedures on page 62.

CAUTION: Failure to follow the predisassembly procedures can result in equipment damage or

data loss.

2. Remove the access panel (see Removing the access panel on page 64).

3. Disconnect the sensor cable from the chassis intrusion switch port (1).

Figure 5-7 Removing the access panel sensor

4. Slide the sensor back in its slot, push the sensor down, and then remove it from the chassis (2).

Installing the access panel sensor

To replace the access panel sensor, reverse the previous steps.

ENWW

Removing and installing components