Specifications

Bezel

This section describes how to remove and install the front chassis bezel.

Removing the front bezel

To remove the front bezel:

1. Prepare the computer for servicing by following the

Predisassembly procedures on page 62.

CAUTION: Failure to follow the predisassembly procedures can result in equipment damage or

data loss.

2. Remove the access panel (see Removing the access panel on page 64).

3. If the security screw is installed (next to the middle front bezel release tab), remove the screw. (See

Front bezel security on page 65.)

4. Lift the release tabs (1), and then rotate the front bezel off the chassis (2).

Figure 5-4 Removing the front bezel

Installing the front bezel

To install the front bezel:

1. Align the tabs discussed in the previous section and rotate the bezel until it snaps in place.

2. If you are using the bezel security screw, replace the screw next to the middle front bezel release

tab.

Front bezel security

You can lock the front bezel in place by installing a security screw provided by HP. To install the

security screw:

1. Prepare the computer for servicing by following the

Predisassembly procedures on page 62.

CAUTION: Failure to follow the predisassembly procedures can result in equipment damage or

data loss.

2. Remove the access panel (see Removing the access panel on page 64).

ENWW

Removing and installing components